Sainsmart 3018 PROVer dustboot

A dust boot designed for the Sainsmart 3018 PROVer which should also fit most 3018 machines with 775 spindle motors.

Video of the dustboot:
https://youtu.be/TsMTuxGBvgU?t=1881       

The files were created in carbidecreate  https://carbide3d.com/carbidecreate/

Materials:
6mm plywood
4x neodymium 10x2mm magnets
2 x M4 16mm button head hex screws

Notes:
Clearance for the 775 motor vents is provided by the 775 spacer plate

The vacuum inlet was designed for 32mm push fit waste pipe which has an outside diameter of 34mm.
You can modify the internal diameter of the vac ring to suit your needs.
I used four rings glued together to support the pipe.
The neodymium magnets are glued into the 1st and 2nd plates with the poles orientated so that the 1st and 2nd plates attract.
I didn't attach a skirt to the dustboot but it would probably improve the dust collection.

Please edit the toolpaths in carbidecreate and edit the tool, speeds and feeds.
Create the gcode
Cut the 775 spacer plate first, if this attaches to the 775 motor ok, then everything else should be fine.

http://www.techydiy.org
https://youtube.com/techydiy
